Quote
Protoprinter
Hi,
at the moment I am building my first delta with a hexagon base with a lot of modified parts of the Hexagon of Fablab Karlsruhe. I have the same plan with a heated chamber. Have a close look at this Blog. It is a Delta with heated chamber and it seems to work good. He has to cool his E3D Hotend with water to prevent jamming. In a heated chamber you don't have fresh air for the Hotend. Please keep this thread or your blog updated!
Kind regards
Manu
I will definitely keep my blog updated. The results from the above blog are very very interesting. I also like the linear bearings he is using. They look like a very good solution to TUKI2 at some point. Thank you for pointing that out, I have never seen it.
I like the results he is getting with a 45-50c range chamber. One thing I did not see in his blog is the water-cooled hot end. I am sure I will investigate this when I get to it. My project is moving a bit on the glacial scale as I keep going two steps forward and one step back. See my nozzle size thread. Its hard to build a printer when your relying on the printer to make the parts.