A thought just occured to me. When printing, is there ever an issue with the FSR triggering, thus signalling that the hot-end has hit the bed, even though it might have just pressed down on the part?
As for the heat bed, I was thinking of using a small heat bed with a large sheet of glass. So I would be limited on the size of my ABS prints, but I could still print large PLA prints without a heat bed. Would that solve the heat issue?
As for the heat bed, I was thinking of using a small heat bed with a large sheet of glass. So I would be limited on the size of my ABS prints, but I could still print large PLA prints without a heat bed. Would that solve the heat issue?