Hi there
I have attached my 0.83 repetier firmware if it helps anyone. This is for a megatronics V2.0 and I have the LCD and Keypad working. This was modified from the Rostock Max firmware. Note that I haven't actually printed anything yet as I am still waiting for my E3D hotend but I have done many hours of dry runs. You will obviously need to adjust the Z-height.
On the LCD while printing, it displays Mul: 100 Buf 16. The mul is the speed multiplication and I assume that Buf stands for buffer but what does the 16 mean?
Has anyone managed to get megatronics to print from the SD card without the USB cable attached? As soon as I pull out the USB cable, I lose power.
Thanks
Roger
I have attached my 0.83 repetier firmware if it helps anyone. This is for a megatronics V2.0 and I have the LCD and Keypad working. This was modified from the Rostock Max firmware. Note that I haven't actually printed anything yet as I am still waiting for my E3D hotend but I have done many hours of dry runs. You will obviously need to adjust the Z-height.
On the LCD while printing, it displays Mul: 100 Buf 16. The mul is the speed multiplication and I assume that Buf stands for buffer but what does the 16 mean?
Has anyone managed to get megatronics to print from the SD card without the USB cable attached? As soon as I pull out the USB cable, I lose power.
Thanks
Roger