Quote
DaveGadgeteer
Quote
Guizmo
Didn't you have interference problems with the center of the herringbones? Once you told me to make a channel there instead.I don't understand this answer--isn't there a tolerance issue with the center of each herringbone? We're not talking about the tooth offset issue here, but mechanical tolerances in the sharp corners, right?Quote
nicholas.seward
@Guizmo: You only need a split between the two sides if you are going to use the same arm blank for both sides. The gears are off by 1/2 a tooth from side to side but there is a 10mm gap.
Yes. I'm talking about this:
[attachment 22036 hbg.png]