I think that moving the supports in takes care of most of the footprint issues. If you pack it in to tight, getting the print out of the machine will be a hassle. A max height / max diameter cylinder will be interesting enough to remove with a sunken print surface. Adding another tight fit isn't going to be very user friendly.
------------
So how long are the lead screws on this version? They look like 3' in the picture, but that's not a good way to figure things out.
--------
With the adjuster screws on the print plate where you have them, the weight of the plate hits pretty close to the weakest part of the mid plate. With a heavy plate (or some heavy filament (:D) that might give you a bit of bend.
------------
So how long are the lead screws on this version? They look like 3' in the picture, but that's not a good way to figure things out.
--------
With the adjuster screws on the print plate where you have them, the weight of the plate hits pretty close to the weakest part of the mid plate. With a heavy plate (or some heavy filament (:D) that might give you a bit of bend.