Re: 3DR "Simple" Delta Printer
JohnSL, Just dropping you a note to say thank you again. I built my Mini Kossel with a E3D hot end. Then spent a lot of time with clogging and modifying the extruder due to push fit popping out,...
View ArticleRe: Kossel endstops
Not exactly. They are there to stop the truck from going off the rail.
View ArticleRe: Rostock Stepper Motor Problem - Help
On my $15 RAMPS, I had to resolder some of the driver pins on Y and Z. I had to first look at the schematic then trace each connection. Do you have multimeter?
View ArticleRe: Rostock Parts no where to be found.
You seem pretty sure it'll all work out....if you are using any other experience as a basis for your optimism you are going to get a rude awakening. Please do blog your progress, you have ideas that...
View ArticleRe: Auto Level problems
With the probe retracted send a M119 command and copy/paste your results.
View ArticleRe: 3DR "Simple" Delta Printer
OK, well that will not work completely because the 3DR Simple, platform.stl, the effector has 4mm between the diagonal rods but the Mini Kossel carriages have 5mm. So, I will have to use the MK...
View ArticleClik here to view.
FSR sensor for autolevel available in stock
Hi , just some words to say that i have in stock some FSR sensors ( fsr402) These are very useful sensor if you plan to use autolevel function on you delta. FSR 402 135-thickbox_default.jpg Autolevel...
View ArticleRe: My Rostock Deltabot 3D printer.
Hey dude.. congrats on your success... do you know if i can get cad files for the printed parts?
View ArticleRe: Is the original design dead?
Well, most of the designs I'm aware of use 3 linear stages, I was asking about this design, or rather, the reasons why it isn't very popular.
View ArticleClik here to view.
Self Adjusting FSRs
It's been a while since I've posted anything to this forum. Part of that is because I have another project I've been working on for the past month, and I wasn't sure how well it would work until I...
View ArticleRe: Is the original design dead?
Many of those listed on that page aren't even 3d printers, they are delta robots. Those designs are extremely complex, fickle in nature, and often costly. Soem require more poerfull motors, which...
View ArticleRe: Self Adjusting FSRs
Have a look here, [groups.google.com], Wing has done something very similar. Andy
View ArticleRe: Self Adjusting FSRs
Thanks for the link. That's a pretty long thread! I posted over there and we'll see what happens next :-).
View ArticleRe: Kossel endstops
I'm not using rails, I did the wheels conversion. I followed your config steps you sent and I have X and Z moving in the right direction by Y is moving downward no mater with direction I try for Z....
View ArticleDebugging Question
Using Reptier 0.91 and Mac Repetier Host Request positive Z movement (up) and X/Z move up but Y moves down Request negative Z movement (down) and all three move down Where should I be checking for...
View ArticleRe: Debugging Question
Just guessing...that sounds like it might be a wiring issue for the Y stepper. You can try swapping the wires between Y and the X or Z to see if you get the same behavior.
View Article